Fisher & Paykel standing water after a cycle
Drainage
Each DishDrawer is its own machine with its own pump, so one drawer holding water while the other runs dry tells us immediately which half to open.
Drain pump
Filter and sump
Air gap
Fisher & Paykel dishes coming out gritty
Wash
The drawers hold far less water than a conventional machine, so a blocked filter changes wash performance much faster.
Spray arms
Filter
Inlet valve
Fisher & Paykel door dropping open
Door
On a drawer the equivalent fault is the lid mechanism rather than a hinge, and it is the part most specific to this brand.
Hinge springs
Door cables
Panel alignment
Fisher & Paykel not holding temperature
Sealed system
Integrated columns set flush into joinery with minimal clearance, which means condenser airflow is checked before the sealed system is suspected.
Thermistors
Control board
Charge check
Fisher & Paykel frost building on the back wall
Defrost circuit
The defrost heater, timer or bimetal rather than the compressor. A fraction of the cost, and the symptom people most often misread.
Defrost heater
Timer or board
Bimetal thermostat
Fisher & Paykel water pooling under the crisper
Drain
A blocked defrost drain backing up into the cabinet. Clearing it is usually the whole repair.
Drain line
Evaporator tray
Heater clip
Fisher & Paykel door locked after a clean cycle
Latch
The lock motor or the thermal switch that reports the cavity has cooled. Do not force it — the latch costs less than the door.
Lock motor
Thermal switch
Control board
Fisher & Paykel not heating at all
Heat
A bake element, a thermal fuse tripped during a clean cycle, or the relay on the board.
Bake element
Thermal fuse
Control relay
Fisher & Paykel lower cavity dead on a double oven
Shared control
Two cavities on one board, so a dead lower oven is often a relay rather than a second oven's worth of parts.
Shared board
Cavity sensor
Wiring harness
Fisher & Paykel clicking that will not stop
Ignition
Moisture or a cracked electrode keeping the spark module firing. Drying and replacing the electrode is normally all of it.
Electrode
Spark module
Burner cap seating
Fisher & Paykel zone will not come on
Surface
On radiant, the element or the switch. On induction, the power board under the glass rather than the coil.
Surface element
Induction board
Touch control
Fisher & Paykel cracked glass surface
Glass
Replaceable as a part. Whether it is worth it depends on the unit, and you get the number before you decide.
Glass panel
Trim and seal
Reseating
